Product Quality Inspection Report Template

have a minimum of a 1/4" (6 mm) radius 4 Do all top and bottom edges of straightedge profiles have a minimum of 1/16" radius (1.5 mm) or chamfer 5 Do all outside corners have a minimum 1/8" (3 mm) radius Cutout Requirements: 6 Are cooktop and sink cutout corners radiused with a minimum allowable radius of 3/16" (5 mm) 7 If a square cutout is used, has the inspector assured that the cut does not extend past the cutout perimeter 8 If cutouts (electrical outlets) extend past the cutout perimeter are they filled with adhesive 9 Is there at least 1/8" (3 mm) clearance space on all sides to allow for cooktop/sink expansion 10 Are cutouts supported within 3" (7.5 cm), of the cutout edge 11 Are stainless steel or lavatory undermount sinks supported with clips or cradles 12 Are all non stainless steels sinks supported with cradles Intallation General Requirements: 13 Is this an interior installation 14 Are tops of cabinets flat and true to within 1/8" (3 mm) over a 118" (3 m) length 15 Is the maximum visible gap 1/8" of clearance between Zodiaq® countertops and the walls 16 Are tops properly adhered using flexible adhesive to support material 17 If inserts are used are they insert and glue type Installation Support Requirements: 18 For structures with 26" (66 cm) depth, is there continuous perimeter support 19 For structures with 26" (66 cm) depth, is there continuous perimeter support and additional front to back support every 36" 20 For structures with support on three (3) sides is there proper support 21 For overhangs exceeding 12" (30 cm) for 2 cm product, and 15" (38 cm) for 3 cm product is there proper support 22 For half walls, knee walls, pony wall overhangs is there proper support 23 Has only acceptable support material (MDF, plywood, structural steel, or wood) been used Installation Seam Requirements: 24 Are all field seams color matched using a DuPont approved adhesive 25 Are all field seams filled through the entire seam thickness 26